Answer / sagar

dc

Answer / balaji

DC is more dangerous, since there is no natural zero in DC
as in AC...

Answer / rajkumar pal

Both are dangeruos but DC is more dagerous than AC because
AC is alternating current & flow of sine wave & once a cyle
is zero and maximum for take reference line, but DC is
direct current & not fraction of time period for reference
line and DC flow of state line,so DC is dangerous.

Answer / art

dc is moredangerous than ac.
based on ac sinosoidal wave, alternating current and voltage
has reaches 0 at at each half cycle which is the weak point.
On the other hand DC has straight wave.

One example is the rail way train which uses dc, because it
has strong torque at starting compare to ac.

Answer / amir

Both are dangerous and it mainly depends on the amount of
voltage and current present......but DC is very dangerous
when compared to AC

Answer / ashish

D.c is more dangerous as compare to A.C.
In case of a.c current and voltge change time to time. And
its value become two times equal to zero.
Vi=Vmsin(wt)
Vi is equal to zero after 180 and 360 degree.

Answer / ranjit burnwal

ac is the dangerous one at the same voltage.. most thinks
that ac permits u to go through 0V which give a chance to
relief.. but the human body is effected by the current not
by the voltage.. since an 220AC will deliver a much more
current than the 220DC so it is more dangerous..
few other thinks that ac gives u the chance to take your
hands off the current.. but this is also not right as the
needed reflection time(at least 0.3sec) is much more than an
AC current will provide you..

Answer / robin singh

dc is more dengerous

Answer / shivanna

dc is more dangerous than ac bcoz in ac the voltage nd
current increases maximum nd decreases to zero it will be
varying but in dc does not varies its constant voltage nd
current.

Answer / sujan neroula

depends on the current because human body is effected by current

During the testing of Electrical Equipment the test cables should not touch the equipments. For that testing engineers use to cotton rope to hang the cable from measuring Equipment to testing equipment terminal. Please explain the technical reason for this practice.

1 Answers  

In simply words(not explain any formula )what do you mean by power factor.?

5 Answers   DRDO,

IN PLATE EARTHING , PLATE LAID IN VERTICAL POSITION ,WHY HORIZONTAL WHY NOT

2 Answers   Airtel,

What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?

0 Answers  

Why Generator KVA not in KW ?

3 Answers   Bygging India, HHH, Tata Motors, TVS,

pls,send the previous year written test questions.

0 Answers  

my UPS is 600VA with 0.6 p.f and i use it for my computer which has 450W power supply unit, a monitor of 633nW and speakers. Can any one explain this.. because the output of UPS should be 360W (<450W)

2 Answers  

Sir, how to calculate the voltage drop and short circuit current of cable. please give me example and formulas.

1 Answers  

No load test of induction motor is carried out to compute= A stator resistance B rotor resistance C magnetizing reactance D rotor reactance

1 Answers  

what is basic difference between the normal tube light choke and electionic choke ?

4 Answers   Amaron,

In brushless excitation system how generator field current is measure even if the slip rings are absent?

3 Answers   Adani,

why star point of motor shall not be grounded?

8 Answers