which is more dangerous A.c or D.C?
Answers were Sorted based on User's Feedback
Answer / manpreet chhabra
dc
but i think u should not have to worry abt all dis.
ok.........
get a shock nd den u will have no confusions in ur mind
try to be practical yar......
| Is This Answer Correct ? | 0 Yes | 2 No |
Answer / ashok
obiously Ac
see let us an example 240volt ac and 240 v dc.. As per my
knowledge a fraction of second is enough to kill a human
being..240 vac will reach 240* sqrt 2. so voltage level is
more in ac due to sinusoidal wave..As per the knowledge
voltage is responsible to penetrate the current into our
body. so voltage is more in Ac....so answer is Ac
| Is This Answer Correct ? | 6 Yes | 9 No |
Answer / srihari
dangerous is dependent upon the voltage and current
levels.in case of d.c . low voltages in between 40v to 150
v is danger than high voltage,but in case of a.c
highvoltages are very dangerous
| Is This Answer Correct ? | 5 Yes | 9 No |
Answer / raju ranjan
a.c. is more dangerous than d.c. becs when ac is passed
through a conductor, it is always the R.M.S. value of the
dc, which is squareroot of 2 times of dc. means ac = 1.414*
dc.
| Is This Answer Correct ? | 19 Yes | 39 No |
What are the different pre-commissioning tests that are performed on the distribution transformer, power cable and switchgear (11kv)?
what is slip rings in an induction motor&what is it's work.
3 phase supply is there Total kw 100 howmuch cable put the load
On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?
0 Answers TNEB Tamil Nadu Electricity Board,
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
what is reluctance?
why cu losses called cu losses.
How damper winding in synchronous motor suppress Hunting?
Size of the 60Hz and 400Hz transformers is a) same b) 60Hz Tr s larger than 400Hz Tr c) 400Hz Tr s larger than 60Hz Tr d) None of the above
what is transformer tap change HT side and LT side
when we switch on the switch and load is not connected at home,is electricity wasted?
what is meant by GD2 ?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)