Answer / ravinder reddy

it wil be approx 25 to 30 kg depending upon the design approved.

Answer / sandip

for residential tower , commercial and also for industrial work = 45 to 55 kg / sq.mt for all type of R.C.C. work

Answer / eng m. noori

Per Sq.m area. if the building is any, 16Kg standard for
RCC slap.

Answer / goutam giri

As per design

Answer / ami.shah

The steel required will be around 40 - 50 kg/sqm of area for RCC Framed structure G + 3 FLOOR . This steel may vary depending upon the different seismic zones and type of structure.

Answer / rajneesh chaturvedi

Figure depends upon the type of member existing in 1sqm, like beam column or slab.
generally the designer preffer 10mmdia @ 150mm c/c in light loading at mid span resulting 8.7kg/m (main+ distribution+ chair) in slab .

Answer / hashim ansari

Between 50 to 60 kg per square meter.

Answer / nitin

1sqm=10.76sqft
For 1sqft=4.2kg
For 1sqm=4.2x 10.76=45.19kg
Means 1sqm=45kg/sqm

Answer / bhuvan

it will depend upon the the plan and the diameter of steel.
if the diameter of steel is 25 then7 kg steel will be
used...

Answer / ush

thickness*length*width*7.86= wt of steel

3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.

0 Answers  

What is the percentage of steel in 1cu.m. RCC?

9 Answers  

for 100 sqm cement concret (1:2:4) 4cm thick floor,the quantity of cement required is

5 Answers  

What is the bending moment ?

1 Answers   L&T, Manav Infra Projects,

How can we calculate quantity of slab, beam @ column ? Beam should be calculated by deducting slab thickness or slab should be calculate in to in ?

5 Answers   SMC,

Brick size ? & 1 square feet brick work for use brick

1 Answers   Ashoka Electricals,

which grade of cement mostly used in construction and why..??

6 Answers   L&T,

why construction joint in the slab should be l/3 of span? what's the technical reason for that?

1 Answers  

Should vertical shuttering done for CC/ RCC for Damp Proof Course (DPC) be measured?

2 Answers  

For elevated service Reservoirs what will be the output of each skilled carpenter and bar bender.

0 Answers  

what is the difference between sill beam,Tie beam and plinth beam?

2 Answers   L&T,

How to make a c++ program that converts any base to base 10?

0 Answers