Answer Posted / rajneesh chaturvedi

Figure depends upon the type of member existing in 1sqm, like beam column or slab.
generally the designer preffer 10mmdia @ 150mm c/c in light loading at mid span resulting 8.7kg/m (main+ distribution+ chair) in slab .

Explain the mechanism of cavitations in pipes and drains?

1167

---

Explain what are the skills required to become an architect?

1219

---

For elevated service Reservoirs what will be the output of each skilled carpenter and bar bender.

2100

---

if dia of slab beam bar is38mm what its clear cover any method of provide clear cover

2104

---

if i used salt as a add mixture in concrete, then what will happen and what are the naturally available add mixtures.

2084

---

why is M25 and Fe 500 assumed to be most economical? i feel it is not.This is because higher grade of concrete and steel has higher lapping length and anchorage length compared to lower grades..

2695

---

I have to design brick column and footing (note: without any reinforcement). Can somebody post me the design or suggest a book where i could possibly find the design? Plz help very urgent

2265

---

3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.

2185

---

rate analysis for cement pointing 1:4 , for 100 sq m

4229

---

Explain major difference between auto level and dumpy level?

1243

---

Where will be the maximum bending moment in a TEE Beam?

7666

---

What is absolute pressure? How absolute pressure is calculated?

1222

---

what is stressing

6778

---

length where bent up is made in slab of bridge from one end

1986

---

what is the water cement ratio of 1:6 and 1:4 cement sand mortar. reply soon

2852

---