what is the function of starter & choke in the tube light
set & how choke give 1000 volts while switching on.

Answers were Sorted based on User's Feedback



what is the function of starter & choke in the tube light set & how choke give 1000 volts ..

Answer / wasim ahmed

choke produces the blast voltage

Is This Answer Correct ?    0 Yes 0 No

what is the function of starter & choke in the tube light set & how choke give 1000 volts ..

Answer / redtedtert

dear Rupashree Goswami .plz dont post wrong answers

Is This Answer Correct ?    1 Yes 3 No

what is the function of starter & choke in the tube light set & how choke give 1000 volts ..

Answer / rupashree goswami

the starter recieves an electrical signal from the
switch,then it engages and springs the flywheel turning the
engine over to prompt it to start.starter is a powerful
elctric motor that spins gasolline engine to make it
start.this is only for starter not for choak

Is This Answer Correct ?    3 Yes 18 No

what is the function of starter & choke in the tube light set & how choke give 1000 volts ..

Answer / hashim

Function of choke in tube light protect short circuit during staring.

Is This Answer Correct ?    12 Yes 91 No

Post New Answer

More Electrical Engineering Interview Questions

In Ferranti effect,Receiving end voltage is greater than sending voltage,why? can anybody tell me the answer

15 Answers   Engineers India Limited,


Shall we use Dyn1 transformer in place of Dyn11 for motor application as a distribution transformer

1 Answers   NSL Sugars,


Best way to measure the Soil resistance of rocky soil, three probe method and four probe method

0 Answers  


How electrical power(MW)is varied OF an A.C Generator in response to varying steam input to a steam turbine ?

1 Answers   Hindalco,


Why charcoal and salt add in earthing pit.

6 Answers   Garware, NTPC, Sterling Wilson,






what is the difference between EMF and potential difference??

3 Answers  


if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?

0 Answers   Delta,


how to calculate capacitor bank value to maintain unity power factor plz xplain with some suitable xample?

4 Answers  


what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:

0 Answers  


what happened when we supply a dc current in dc motor?? can it worked properly?

0 Answers  


why eee branch?

1 Answers   TCS,


what will be the minimum megger value for 132 Kv (earthed) potential transformer

3 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)