How is the Depth of Stator Slot being calculated for Synchronous Generator?

2 Answers  

---

Why single core cable required bonding at double end.

1 Answers  

---

What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?

0 Answers  

---

what is difference between start imitation and start interlock for 3 phase motor protection ?

2 Answers   OPS,

---

what is diff between Ground/Earth & Neutral?

4 Answers  

---

If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?

0 Answers  

---

What is an Antipumping relay ?

4 Answers  

---

What is difference between PVC cable & XLPE cable?

14 Answers   Intertek,

---

What is the difference between cylindrical-type and sandwich-type winding?

0 Answers  

---

At 765Kv, I have seen the use of PT at line side for metering and CVT for protection, although as far as my knowledge is concern, PT at this voltage level will have huge loss and more cost as compared to CVT as CVT can also perform same function of Protection and Metering? So my question is why use PT and not CVT for metering and protection in order to reduce the cost.

1 Answers  

---

what is the function of turbo in dg sets

1 Answers  

---

how we are desining 63.5 ohm resistor for NGR of alternator?

1 Answers  

---