a induction motar has 30-35%
exciting current at
no load but in transformer it is
only 2-3% ofbrated
current why any reason?



a induction motar has 30-35% exciting current at no load but in transformer it is only 2-3% ofb..

Answer / sheikh

Transformer is static equipement not a rotary equipment
hence a little bit current observed which may need due to iron
losses . motor is a active and functional parts whatsoever
on load or off load thereby taking 40% approximatelt as
respect to rated current.

Is This Answer Correct ?    6 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???

0 Answers  


IR value for 30kw lt motor

1 Answers   Hofincons,


When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number

0 Answers   TATA,


how i chosse capacitor bank if my energy meter is 48 kvr? tell me capacitor bank chossen formula?

1 Answers   ACC, Bhel,


Why syn. Generators are used for the production of electricity?

0 Answers  






what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem

0 Answers  


what is the difference between between open delta and broken delta?

5 Answers   Reliance,


Why donot sleep below the tree for night time?

12 Answers  


Dear All, In a 400V power system, ratio of three current transformers installed incoming switchgear is 4000/1. Maximum three phases short circuit current of this system is 48kA. One CT is installed on neutral of upstream transformer (6/0.42kV, solidly earthed) for 51G protection. Would you please inform me about the correct CT ratio of this current transformer (on neutral)?? Thanks a million

2 Answers  


which level of transformer oil has got low dielectric strength ?why?

2 Answers  


A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????

8 Answers  


how could we know the size of cable by physical view?

0 Answers   Havells, United Engineering,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)