ground floor columns and beams are reinforced by 4 Num's 16MM @ Corners AND 2 Num's 10MM @ centre.... And the nxt top floor columns and beams were lapped by 8 num's 12MM dia bars.....
IS THIS CORRECT ????
Answers were Sorted based on User's Feedback
1m=3.281feet in that what is .281 mm cm m or anyother
For a washout valve why are two gate valves required in normal practice?
how to consider the lap length of a bar in IS code and specify the code book name and clause& page number?
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
How much steel required for only ground floor of 1600 Sq foot.Having general structure ?
whta are the types of columns
How musch steel i.e. angles, channels,and square pipes are required per square feet for a steel roof of residential two storied building?
What is the design mix? What is the proportion for M25, M35, M40 concrete mix.
9 Answers ACC, DBM, Era Infra Engineering, Thakural Constructions,
how do you stabilize a waterlogged area in road construction
where you provide overlap on column?
what is zone a n zone b?why the spacing of ring in zone a less.n zone b high?
give me the rate analysis for Bituminous Macadam and SDBC
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)