Answer / vinothkumark

yes. because transformer is a bi directional divice

Answer / parthi

yes, we can transmitt....because transformer working by the
mutual induction principle and we can use the transformer
upto required voltage and use step-up and step-down....

Answer / avnish kumar

yes we can use the said transformer to step up the power. i.e if we used a 132Kv/11KV 5Mva transformer thus we can received the power cap. 5Mva at 11Kv level, but in case of step up i.e 11Kv/132Kv the generation point is 11Kv in this case the firs generation point i.e 132Kv generation capacity should be less than the capacity generated by the 11Kv generator. but over all capacity should not be more than the capacity of transformer.

Answer / yassir

yes we can but incase the frequency is the same for
generator and the grid.

Answer / islander

Possible.But,In practical stage you have to see how transformer,generator and bus bar protection have configured.You will have to alter some directional type protection schemes to the bi directional.

Answer / sourabh maggo

yes exactly we can use same transformer for step up & step down applications,,

explain why direct on line starting toque and current may not be acceptable

2 Answers   Avon Organics,

.What do you mean by Turbine Dump.

1 Answers  

What is df/dt protection?, How to calculate setting range of 30 MW steam generator???

1 Answers   DS Sugars, MEMF,

why IBD Vent is kept at higher elevation than CBD ?

5 Answers  

LAPT working in alternator / generator

0 Answers   Power Plant,

We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?

0 Answers  

what are the major duties of a instrumentation engineer in a power plant.?

3 Answers   Gulf,

explain(why) with circuit for pick up of restricted earth fault protection due to external fault

1 Answers  

what is the formula for converting mmwc to tph in a dp type transmitter.what is the range in plc(in tph) if dp tx.range from 0 to 5000mmwc.

2 Answers   CCC, Korba Power Plant, Shyam Steel, Utkal Alumina International,

what is turn down ratio

4 Answers  

what's interlock relay ?

3 Answers   International Mega Food Park Limited, National Power Training Institute NPTI,

What is creep, resilience.

2 Answers