Answer / k.prakashchandra

See whether temperature compensation can be provided

Answer / rahul anand

generaly recomended that relaysetting forline must not exceed more than 3 seconds but we can also put 5 second during winter if we find frequent tripping of lines

By any way can we increase the B check hours from 300 to 500

0 Answers  

---

What is droop.

2 Answers   Dhampur Sugar Mills, Elaf,

---

What vibration parameters are monitored in a directly coupled single cylinder turbine and generator?

1 Answers  

---

Is it not bad to bleed steam from turbine stages before utilizing its energy.

2 Answers  

---

what is the meaning of SST300 V56A in SIEMENS turbine

0 Answers   Siemens,

---

Why attemperation is required in HRSG in a combined cycle power plant?

10 Answers   Tata Power,

---

why prds line tapping taken from ms line as Pri SH O/L temp & pressure is sufficient to full fill our requirement of PRDS..

3 Answers   GIPCL, OEGI,

---

What are the motors used in a thermal power plant? (With type and ht/lt) What voltage levels are used in a thermal power plant?

2 Answers   OPG,

---

Why the steam Turbines are Designed Higher side compare to Alternator

1 Answers  

---

What is tripping relation between the turbine exhaust pressure and turbine last stage pressure....???

1 Answers   Jaypee,

---

What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?

0 Answers   RasGas,

---

DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.

0 Answers  

---