what is the formula for converting mmwc to tph in a dp type transmitter.what is the range in plc(in tph) if dp tx.range from 0 to 5000mmwc.

Answers were Sorted based on User's Feedback



what is the formula for converting mmwc to tph in a dp type transmitter.what is the range in plc(in ..

Answer / bikash mohanty

We know that 10m of water coloum can creat 1kg of pressure head.so 10000mm of water coloum can creat 1kg of pressure head. Also we know that 1000kg =1ton.
10000000 mm of water coloum can creat 1tph.
So we can now calculat for 5000mmh2o= ? Tph

Is This Answer Correct ?    40 Yes 12 No

what is the formula for converting mmwc to tph in a dp type transmitter.what is the range in plc(in ..

Answer / ravi kumar

Convert MMH20 to diff pressure bar
BAR TO M^3/HR
M^3/HR TO TON /HR

Is This Answer Correct ?    6 Yes 1 No

Post New Answer

More Power Plant Engineering Interview Questions

what is voltage transformer explain in details

5 Answers   Khulna Power, NCC, Reliance Power,


DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.

0 Answers  


What are the special criteria under which FD fans are switched off during MFT.

1 Answers  


what is the meaning of SST300 V56A in SIEMENS turbine

0 Answers   Siemens,


What is tripping relation between the turbine exhaust pressure and turbine last stage pressure....???

1 Answers   Jaypee,






line safety is not opening but drum safety opens what to do?

3 Answers  


what is turn down ratio

4 Answers  


What will happen if id fan on boiler not functioning?.Can the Boiler run without id fan? What is the effect?

4 Answers  


In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,


Why superheated are started before I'd and rd fan?

0 Answers   BCPL,


what equipment is most efficient in power plant?

4 Answers   Adani,


Need of oxygen dosing in super critical powerplants?

5 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)