DCS marshaling Cabinet Power supply can be replace during plant running time?
Answer
Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy.
MY question is how switching done.
No Answer is Posted For this Question
Be the First to Post Answer
What happens if lizard comes in a MOCB
What is MFT and when it is acted.
What is wheel chamber in steam turbine?is it impulse blades are called wheel chamber in the steam turbine?
what equipment is most efficient in power plant?
What do mean by 3t
1 Answers Aman, Birla, Grasim,
what is the basic use of power plant in equipment
What is df/dt protection?, How to calculate setting range of 30 MW steam generator???
why seal air fan is used and where it is used and where is suction taken from
What is the over speed in turbine? What is critical speed?
how many safeties should be present in boiler?what are they?
4 Answers DN, Nandi, Pump Technology, Siris, Thermax,
how shall you calculate PLF on the basis of percentage auxillary load factor
under which situation or why restricted earth fault protection operates in out side its zone that is external fault
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)