Answer / sumeet

First of all please estimate your mill load, office load
(lighting load and air conditioner load).
As per you have shown 600 hp load your contract demand will
be 447.6 kW i.e 527 KVA considering 0.85 power factor

Answer / k.prakashchandra

Contract demand is based on demand factor which to be
assessed or obtained from a similar industry.Once you enter
into agreement with the supplier ,you will have to pay the
demand charges during the entire period of agreement.If you
take the demand factor as 0.8 ,your CD will be 425 KVA at
0.85 pf..You can start with a lower value and ask for
sanction of additional CD if the MD exceeds the CD.Normally
you are unlikely to be penalized for exceeding CD during one
month ,depending on prevailing supply rules .

which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing

0 Answers  

---

what is the meaning and difference between ELECTRICAL DRAWOUT and MANUAL DRAWOUT?

3 Answers  

---

We have 800KW motor operating at 6600Volt,50 Hz supply.During 1st startup it tripped on overcurrent trip.It's FLA is 88 Amps.The K factor of Thermal overloaaad was set on .94 initially.then we set at 0.97 and then it started fine.i dont understand why it tripped first?What are the protections which comes in picture during starting ?

6 Answers  

---

How many turns are there in primary winding? (In Transformer)

0 Answers   Philips,

---

Name one of major transformer company in KSA ?

0 Answers  

---

---

Define the overload capacity of the motor.

3 Answers   Alstom, Maynilad,

---

What does VVVF stands for in VVVF drive ? How does it differ from VVF drive?

8 Answers   HAL,

---

1)which height building required lightning arrester? 2)how to calculate the requirement of lightning arrester? 3)what is the pro instrument? 5)how to test protective relay like overload?earth fault relay?

1 Answers  

---

what will happen if the bus PT fuses are accidently removed from the circuit in 6.6kV feeder?

1 Answers  

---

700KW 6.6KV slip ring induction motor to use VFD to control the speed

0 Answers  

---

Suppose i Have an Ac motor of 25Hp 1500 Rpm 50 Hz Can i run a motor 2500 Rpm by AC drives by increasing a frequency either it safe or not ....

2 Answers  

---

if the transformer at full load have a iron loss =900w and copper loss = 1600w . what percent of the load will the transformer has a maximum efficiency?

3 Answers  

---