Answer / ecb 04-03-06

a motor of different h.ps can be connected by use of drives
by diff. gear ratios power can b edistributed &as well can
be asemble

Answer / sennapparajan

can be connect through using VFD;s. through vfd we can run
the motor at any HP rating by programming.

Answer / pillay

I think you were asked about a motor that can be connected
differently to get a different HP rating. You have to rely solely
on the connections options given on the name plates or the
manufacturer.Sometimes the same motor can be connected for
different RPM and different HP.

Answer / ahmadmukhtiar

First of all the question written is wrong. Either you say
that how to connect motor and vfd with different ratings.
This is simple. VFD's are programmed and motor having
different HP can be run.Or else explain whether you want to
replace an existing motot with a different HP motor?

Answer / manish jain

It depends on the application where you needs to get these
motors connected. Gear ration already given as an answer.
For pumping stations valve throttling, will serve the same
as gear ratio.

for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?

0 Answers  

Calculate the demand in KVA for a three phase 440V power source drawing 1100A current

5 Answers  

If OLTC is in manual position there is chance to variation of voltage(Low or High)?

1 Answers   Juniper Networks,

how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.

0 Answers  

if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer

1 Answers  

sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.

0 Answers  

If you touch at the end welding machine, will you have shock ?

1 Answers  

do we need NGR panel when the output of the genset is LV but after that it is step up to 22 kv. condition is 12 genset 400v are operating in parallel.

1 Answers  

Ohms law explain

1 Answers   Hetero,

How to work E.L.C.B and how to connect in circuit.

0 Answers  

I have CNC Turning lathe,while doing electrical preventive maintenance what should I do & please brief me plan & shedule for the same.

1 Answers   DRJ ARDE,

wat is d first thing to be seen 2 lay a cable in a particular area??

1 Answers