Answer / pushpu

yes,we can.because lamp is resistive load so no effect on
lamp due to 220v DC.

Answer / sree

Lamp is a resistive load, so we can use. However the light
produced in DC supply is more because of less impedence.

Answer / vinay kiumar

Yes we can use the incandescent lamp both A.C as well as
D.c pupply because incandescent lamp act as resistive load

Answer / sayan

if the lamp is incandescent, then answer is YES

Answer / barbara wild

hallo,i was just reading your question ...i am looking for a
lamp 220v 15 w and cant find them in germany could you let
me know where i can order them ? thanks barbara

Answer / barbara wild

sorry i ment lightbu

from which subjects most of the technical que will b asked for hpcl(electrical).pls help me

0 Answers   ABB, HPCL,

Define the term factor of inertia.

0 Answers  

why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??

0 Answers  

how to reduce the power consumption in office ?

6 Answers  

By just seeing a transmission tower, how can we knew the voltage it carries..?[110kv, 220kv, 400kv...]???

5 Answers   KSEB,

why the transmission side of the generating transformer is always star??

5 Answers  

how to find total current when kva is 30.4 given ? should we use root 3 (1.732) in the formula?

2 Answers  

what is the method to measure the transformer current carrieng capacity in three phase.

1 Answers  

which signal we found accurate reading of analog signal or degital signal and why?

1 Answers  

how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .

0 Answers   Birla,

what is the applicatyons of the slipring motor and please tel me more about the slipring concept

1 Answers  

How does the phase sequence controller works, how it identifies the phases? confirm working principle

0 Answers