Answer / suhail javed

transformer is a static device that changes voltage
level,unlike motors which are electromechanical device n
convert elctrical energy into mechanical energy.... suhail
AMU

Answer / abhidewas

is simple yaar ..
we are not changing electrical energy into mechanical energy.
so there is no need of any rotational part.

Answer / thowsif

Transformer is a static device which transfers voltage from
one circuit to another circuit without changing the
frequency(changes the voltage level).

Thier is no generation or Converation of Energy,So thier is
no need to cut the magnetic field as in case of Motor or
Generator to prdouce the Energy...

Answer / jyotirmaya patra

Transformer is a static device which transfers voltage from
one circuit to another circuit without changing the
frequency(changes the voltage level). The working principle
is dpends upon mutual induction which is created by the
alternating or rotating magnetic field. SO transformers are
not rotating type.

Answer / vishnudev janagaraj

transformer is not electromechanical machine.It works on
the principle of mutual induction.current flowing in the
primary coil produces magnetic field which inturn induces
emf in the secondary coil.Based on the number of turns we
can classify the transformer as step-up or step-down.This
is the reason why transformer is not rotating

Answer / vishnudev jangaraj

transformer is not electromechanical machine.It works on
the principle of mutual inductance.current flowing in the
primary coil produces magnetic field which inturn induces
emf in the secondary coil.Based on the number of turns we
can classify the transformer as step-up or step-down.This
is the reason why transformer is not rotating

Answer / yuvi

If rotating, it would no longer be called a transforment.
It will be called an Induction Motor.

Answer / amjad

Transformer doesnot have ROTATARY PART..

Answer / r.kumar

transformer convert electric in to magnetic and again that
energy convert in to electric energy thatswhy no need to
roatating .transformer convert energy in mutual induction
principle.

Answer / 1120

Transformer is not rotating in order to avoid the losses
due to rotating motion. Thus, increasing the efficiency of
transformer.

two TG running in parallel at equal load.one TG CB tripped in reverse power relay.after tripping found its excitation was on & turbine running at rated speed.Please clearify why that TG tripped in reverse power ?

1 Answers   Bhel, Birla,

What does Bode plot tell you?

0 Answers   Ericsson,

why dimmerstate always connected in star connection? what will happen if it connected in delta?

0 Answers  

we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.

3 Answers  

AMF (auto mains failure) control for DG sets at home.

1 Answers  

How many methods use the load flow solution?

0 Answers  

exolain the star delta connection

0 Answers   Toyota,

What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter

0 Answers   HCL,

we erected (48HP)63kva dist transformer and incoming from 11kv line,out going is 415v domastic line 2.04 km.for that actual output current is 84A. what are the losses and final output current.

3 Answers   Essar,

why diesel tank is earthed

1 Answers   ABB, NTPC,

why frequency meter is connected in parallel in a circuit?

1 Answers   University of Engineering and Technology,

Why auxiliary transformers are not connected in parallel in primary stations?

0 Answers   Adweb,