We have received supplies of the ordered material. payments
against the supplies also released. Where ST paid 4%
against form C. Meanwhile it has been observed that 25% of
material supplied was defective. Please suggest whether the
issuance of C form from our side would be stopped till
settlement of liabilities.
No Answer is Posted For this Question
Be the First to Post Answer
What is the Maximum Power generation capacity of a Synchronus Machine ??
Explain principle of Soft-starter & how its working???
If Three Runs of 1Cx300 Sqmm Cable between Transformer and VCB and the distance between 100mtrs. what will be total length of Cable and if cost 1500Rs per meter,what would be the total cost
what is the current setting for different relay protection for transformer .
if voltage in transmission line more than current will be more or less,if less what about the Ohm's law
what is OLTC and difference between RTCC and OLTC
WHY WE DO NOT TAKE THE POWER FACTOR MORE NEARER TO UNITY IN AC GENERATOR?
Which of the following can be operated at higher frequencies ? -SCR -MOSFET -IGBT
What is the different between Insulator & Di-electrict?
how to calculate short circuit breaking capacity KA for 2500kva 33kv transformer.
what is the difference between normal motor and flame proof motor??
what is the working of air compressor.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)