Answer / king

P=root3*VI cos¡è.
this is the formulae for your question?
where
root3=1.732
V =APPLIED VOLTAGE
I =FULL LOAD OF THE
MOTOR
cos¡è=0.85
P= rating of generator

Answer / moitrita roy

2nd ans is the total sum of that 3phase is 40 amp.

Answer / moitrita roy

YAP...
13.33 at one phase

Answer / awaisranazai

thnxx king :)
plz also answer my this question.....u answerd me one
question...other is

and also tell me that this 40 amp at all phases mean 40 amp
on red,40 amp on yellow,40 amp on blue......
or the total sum of that 3phase is 40 amp....

Answer / awais ranazai

U mean 13.33 at one phase

Answer / shocksridhar

In star i phase and i line is same ..,we are using star for distribution transformer so r phase curent and ry curent wil b same nly ..,u must undrstand frst...,

Answer / srinivas v

P=root3•v.I/1000
=1•732*400*40/1000
=27.12
So your gender 27.12kva

pls tell about gas insulated substation?which gas is used for that substation?above which rating we are used this substation?how we take maintenance in that substation?it means substation fully shutdown or live condition?if live condition means how?pls clear this things

1 Answers   Essar,

how we can classify the circuit braker???????

1 Answers  

WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB

0 Answers   IBM,

If a 1.5V,3W torch light bulb is connected in series with a 15HP/11.19KW,230V single phase motor and the combination is connected against a 230V supply and switched on than what will happen keeping all other parameters as it should be A)the bulb will glow normally B)the bulb will not glow C)the bulb will glow with extra brightness D)the bulb will burn out and if a fuse is connected to the above circuit will something happen to the fuse and what about the single phase motor will it be affected? Please explain with derivation

4 Answers  

why the supply frequency in india is 50hz?

2 Answers  

what is pilot wire protection? wer is it using?

1 Answers  

Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua

3 Answers  

what is skin effect? why is it absentin dc system

22 Answers  

1.What is effect of capitance in transmission line? 2. After raising the voltage at receiving end what will be happen? 3.how we nullify or control the raised voltage at receiving end?

3 Answers   NTPC,

in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????

0 Answers   Divis Laboratories,

th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.

0 Answers   HMC,

with help of neat sketch explain principle of TIG welding process

0 Answers