relation between flow and differential pressure.
Answers were Sorted based on User's Feedback
Answer / sandy
Flow is proportional to the square root of differential
pressure.
Is This Answer Correct ? | 98 Yes | 3 No |
Answer / manash ranjan jena
pressure drop across the flow element is proportional to
the square of the flow rate
Is This Answer Correct ? | 72 Yes | 7 No |
Answer / hassi berkine
q(flow)=k(constante).square root diff pressure
Is This Answer Correct ? | 37 Yes | 0 No |
Answer / sachin
flow is directly proportional to the square root of
differential pressure(f=k*sqrt(p1-p2))
Is This Answer Correct ? | 30 Yes | 2 No |
If we are using "restricted type flow mesurement principle
such as Orifice, Ventuary, V-Cone flow meters, anu-bar etc.
then the Pressure drop across the element i.e. delat P,
then Flow is proportional to the square root of
differential
pressure.
Is This Answer Correct ? | 26 Yes | 3 No |
If pressure difference is high definitely the flow will high and if DP(differential press.) became low or zero, means line is partially/ fully chocked. and as we know Flow = square root(DP.
Is This Answer Correct ? | 14 Yes | 4 No |
Answer / ramprasad
Flow is a continuos process of flowing of any liquid.
Differential pressure is the pressure difference between
Suction pressure and Discharge pressure.
Is This Answer Correct ? | 33 Yes | 46 No |
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
During the design and engineering of a process plant, a good designer should plan for ____________, ___________ and ____________ aspects of the plant
what is the difference between laminor flow and turbulant flow
Is that Speed Probe and Vibration Probe sensors are same,if yes what is the diff b/w them?
how we can calibrate an Interface level transmitter online
hi am durga, i just now completed my eie [2009] , can anyone please guide me what r courses i need to join to enter into core company
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
Why Flow measure in Square-root?
what is difference between E/P positioner and I/P positioner. Why E/P fixed in below actuator and why I/P fixed in other place
I work on a electronic positioner transmitter 4211 at the field.I connect my multimeter in series to get the current output then I calibrate it to 4ma in 0% of position of the valve and 20ma in 100% position of the valve.My problem is in the field I get the correct output current based on my multimeter but in the dcs they only receive 40% in a output 20ma of this positioner.Then I try to simulate in this analog card and they receive the equivalent percent on the value that I simulated.Is ther any possibility to reset the zero and span of this positioner 4211 fisher.And what other possibility I can do to fixed this.This is my email add ( landicho_randy@yahoo.com )
Please can anybody tell me the step by step procedure for calibrating the Pr,Lvl,Fl,Temp transmitter on process?
What are the disadvantages of Human-Machine Interface (HMI)? atleast 3.