relation between flow and differential pressure.
Answer Posted / sandy
Flow is proportional to the square root of differential
pressure.
Is This Answer Correct ? | 98 Yes | 3 No |
Post New Answer View All Answers
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
If P will increase then what will happen with PID?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How do bending tubing provide better measurement than using tubing fittings such as elbows?
Why flow/pressure transmitter before control valve?
In Safe Guarding test what means by "Failed to Danger" ?
what is the protection system in solar turbine compressor
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
Explain pH, Conductivity.
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
Coal mill Instruments Equipments for cement plant And process diagram ?
why we r opening HOT BYPASS valve during startup of a compressor?
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.