relation between flow and differential pressure.
- 7 Answers
- 30019 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / sachin
flow is directly proportional to the square root of
differential pressure(f=k*sqrt(p1-p2))
| Is This Answer Correct ? | 30 Yes | 2 No |
Post New Answer View All Answers
How to convert Differential pressure to flow in TPH
What is motion balance principle?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Which topics are covered in Process Control?
Explain working principle of lvdt?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
I will attend an interview with GasGas company for a position of Instrument Technician ( Offshore )in next month can anyone tell me what questions they will ask. Thanks in advance.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
please send the drdo exam paper
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
