Answer / viren chocha

lrs is connected to the sliprings of induction motor.it require for adding external resistance to ckt for controling the huge starting current and attain high starting torgue.once induction motor attain speed,lrs is disconnected from ckt.
it is made of combination of water and some portion of caustic soda

Answer / othman atig almatrafi

simply we use LRS for reducing the starting high current( to operate the equipment safely) and gain high torque.

as ph value more as the resistance became more.

Answer / venky

How to know that resistance value

Answer / gift

what is the chart or ratio of filling up a tank of a liquid starter.

Answer / iam chaturvedi

Combination of water and caustic soda for improving the resistance in starter, that's called Liquid Resistance starter. If any slip ring Induction motor, at the time of starting given the external resistance required to rotor side, why because starting current and starting torque is very high. So we are using resistance starter depend on motor capacity , at that place using Liquid resistance starter. Liquid resistance starter (LRS) ,IN which external resistance is liquid media which is use for the starting method of slip ring motor. For starting of slip ring motor external resistance are required so that we use liquid (addition of some caustic soda)as resistance so that is called as LRS.

1.what type of wave is produced from i.online ups ii.offline ups iii.inverter.why don't we use inverter instant of offline ups for computer,what's the reason?

2 Answers  

What will be the diameter of pipe between conservation tank and transformer

0 Answers   JLL,

how to compute kvar in substation feeder to improve power factor and sending voltage

0 Answers  

what do you mean by 1 ton in AC`s

36 Answers   Bhel, Bosch, ITC Infotech,

Explain what are inter-poles and why they are required in a dc machine.

0 Answers  

a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5

0 Answers  

can we correct the p.f.of ac generator?

2 Answers   APGenco,

HOW WOULD YOU PRESENT THE POWER FACTOR PRACTICALLY ON A GRAPH

4 Answers   Bhel,

What is the permissible maximum flux density in transformer core?

0 Answers  

why stay insulator is not used with stay wire for 11kv Lines. Whereas it is used for LT lines ?

2 Answers   Essar,

if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer

0 Answers  

what is the purpose of taking HV test in LT panel.

1 Answers   PCE,