Why we should use delta connection in primary and star
connection in an distribution transformer, which converts
400v a.c. voltage to 33kv.
Answers were Sorted based on User's Feedback
Answer / ravishankar.m
Generally we recevied power supply from HT.In HT side there
will be not available neutral source so in primery side we
given delta connection.But in secondary side we must need
nuetral for three phase & single phase equipments so we
will create from oueself (create from earthings) so here
the connection must be a star connection.
Is This Answer Correct ? | 0 Yes | 2 No |
Answer / jitender kotwal
AS the transmission line are designed in KVA rating which
are so to reduce the size of conductor and to reduce the
cost so at primary side it is always Delta connections and
for distributaion site it is star cinnection with a line
voltage of220 volt and all electrical equiments are
designed for the same voltage in india
Is This Answer Correct ? | 0 Yes | 3 No |
Answer / premsingh
we use delta connection in prymary becouse in prymary we
need step up the voltege & in delta connection line voltage
is more then phase voltage & we use star in secondry bcoz
in star connection provide us nutral which is nessery for
distibution because all home applances work with phase &
nutral so we use star connection in distribution end.
Is This Answer Correct ? | 0 Yes | 3 No |
Answer / sunil kode
Nuetral in used in single phase system and 3 phase 4 wire
systeme due to we star connection in secondory. in primary
used 3 phase system.but suresh kumar why not convert
voltage from 400v to 33kv.p/s explain the reason.
Is This Answer Correct ? | 1 Yes | 5 No |
Answer / raja
suresh its stepup X-former we need to increas de voltate
level please ref curent equation of star and delta
conection u can get apt answer
Is This Answer Correct ? | 2 Yes | 13 No |
What it the purpose of parallel phasing transfomers??
0 Answers Asia MotorWorks AMW,
what curve and rateing would you use for a three phase 0.75kw motor?
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
What is the Levels of High Voltage, Medium Voltage & Low Voltage?
What is the difference between MPCB and OLR?
Dear All kindly let me know that I know about the DG Rating for Example 150 KVA,Now how i will know that how much Ampher load it can offoard.
What is the difference between Derived earth Fault and measured earth fault.How it works.
what is the differnce between high impedance relay and low impedance relay
how to calculate cable size by amp
effect of single phase transformer on full load current?
what is power factor?
if the back emf eqution for dc motor EB=(QPNZ/60A) THEN what is the value of A for PMDC MOTOR OR how can dicide the value of "A"