Answer / rajneesh

Free wheeling diodes are used whenever inductive loads are
switched off by silicon components: in relay drivers,
H-bridge motor drivers, and so on. A switched-mode power
supply also exploits this effect, but the energy is not
dissipated to heat but used for pumping additional charge
through the load.
this is the reason......

Answer / ranjith

In order to avoid the ripples in the circuit

Answer / karpagam

Freewheeling diode improves the input power factor by avoiding voltage reversal.This diode safely dissipates the energy stored in the inductive load when the thyristor is turned off.

Answer / himanshu srivastava

During the positive half cycle inductor charge as same as the polarity of the dc output voltage. When the negative half cycle started, the inductor will act as a source and it will make the freewheeling diode forward bias. Hence the output voltage become zero and the inductor current will gradually reduce. So that in the output, the current will be there even the output voltage is zero.

Answer / sachin kumar airan

avoid from nagative voltages at the output.to improvement
of powerfactor.to avoid the current flow in reverse
direction.

Answer / mrunali

As name indicates the free wheeling diod gives free moment
to the current through the inductor while discharging mode
of operation. it reducess the voltage loss in the inductive
load.

how to cal calculate capacitance in DC Circuit

1 Answers  

depletion layer will form beforre biase or after bias ?

2 Answers  

why receiving end voltage increases in a system when capacitive load is added

1 Answers  

What does CDG,CDAG,CAG,VAJ,VAJH,VTT,VAZ,VAA etc. stands for in case of relays and can anyone answer to decode this codes C,V,D,G,A,X,TT,J,JH etc

4 Answers   HNL,

what is dyn 11

3 Answers  

How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?

0 Answers  

sir i am fresher.can you please tell me how can i get certificate of competency as electrical supervisor.

1 Answers   ONGC,

what is the RMU and RMU system in sub-station(11kv,66kv.....)

2 Answers   Alstom, Torrent Power,

State angle criterion.

0 Answers  

what is the function of conservater in transformer

3 Answers  

what is the difference between skin effect

0 Answers  

2. What are the parameters of EHT sub-station?

0 Answers   APGenco,