why free wheeling diode is connected across inductive load
Answer Posted / sachin kumar airan
avoid from nagative voltages at the output.to improvement
of powerfactor.to avoid the current flow in reverse
direction.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
What are approaches to tackle sedimentation problem of reservoir?
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
What is mean by hot and cold loop testing?
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
what is ramping rate of generator
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
What happened when capacitor connect series in ac circuit?
Why the cores of large transformers build up of circular cross section?
how to determine ct ratio in ht vcb?
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
When we use 3 terminal resistor?
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.