sir,
i preparing hpcl,ongc,barc,hal exams(instrumentation
engg)pls send a placement papers
Answers were Sorted based on User's Feedback
Answer / ajay sarnekar
Please send me the HPCL, ONGC & BARC technical and apti AT
ajay.sarnekaar143@gmail.com
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / piyush pant
well you are thinking very good.
i will pray for your tarraki..!
Is This Answer Correct ? | 5 Yes | 6 No |
A DP Endress and Hauser flow transmitter is always tripping pump at low flow. set point is 74 cubic meter/hr. Thorough impulse line flushing and zero calibration has been done, yet problem persists. What do you think is the problem and how do you rectify this fault?
i have level transmitter -400 to 0 range for steam drum application but i am unable to calibrate if installation of lt below lower tap what will be the effect ? and as per std wht is location of lt ,above lower tapping or below
what is difference between total flow and flow rate in general ?? explain it with daily life example.
What is the PLC Level & type.
2 Answers Bhushan Power Steel,
How to decrease opening & closing time of on/off valve?
whyvibration probe (bently nevada ) is set -10 volt for zero reference?
what is the differnce between PLC & DCS
what does mean by analog output trim and where this one used for?
What is meant by GAP VOLTAGE, in vibration measurement. Normally how much GAP VOLTAGE is set and state the reason.
How to erection of DCS Panel at site step by step
What is the use of temperature compensation?
What different types of problems do occur while doing the loop checking? and please explain in detail or mail me at kadam.aniket143@gmail.com
1 Answers Operational Energy Group, Process Control Technologies,