Answer / haridass

Displacer type level transmitter is used in interface level
measurement and closed tank level measurement. It is
working under weight loss, the archimedes principle.

Answer / balaji

Level displacer is used in tank gauging system.
mainly it is used in Flate and Tape tank Gauging
system.Which is for detect the level of liquid in the tanks.

Answer / sunil

It is used for tank level measurement where the process is
Vessel/ Tank is having two or more specific gravity

Answer / bharath

were principle of archemedis is applied

Answer / ravi sankar

in leveltrol

Answer / bsrath

in poewer plant it is used in HOTWELL & LP HEATER Level
measurement.
make-v-automat
dresser.

Answer / anishkumaran

Sunil is correct...

Answer / naga

Displacer level measurement is used in interface where two or more different S.G available.

Answer / ilaiyaraja_s

level displacer normally used tank level measurement for any liquid level measurements depends on liquid with h*d calibration

WHAT IS SELF CLEAN ELCTRODE IN MAGNETIC FLOWMETER?? WHAT DO YOU MEAN BY THIS TERM??

2 Answers   IOCL,

What is the minmum distance between the electrical panel and Instrument panel

1 Answers   Dodsal,

Is there is a device to convert mechanical energy to electrical energy

4 Answers  

what is commissioning.

2 Answers   Takreer,

What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?

0 Answers   Engineers India Limited,

What are the interlocks we have to check during the start up of LP/HP compressor?

0 Answers   Hamsco,

Hi Friends , i need one urgent help , i am preparing for M.tech entrance examination , i need some obejective questions related to instrumentation field. where can i get those ? can anyone help me pls ?

0 Answers  

i have a dp tx range is 5000mmwc. in which calibration i use in a open tank.1.5*3.5*2.5 mtr.for level msmnt. what is the calculation.

2 Answers   Bajaj Hindusthan,

why the steam drum and deaerator level transmitter range is in negative MMWC to zero

3 Answers   Emerson, Jindal, JKPM,

Where are oxygen analysers installed in cfbc boilers? What are their usual readings?

0 Answers  

Why 1-5 vdc a standard?

1 Answers   Process Control Technologies,

I HAVE PRESSURE TRANSMITTER WITH TWO WIRES 24 VOLTS SUPPLY.IF TRANSMITTER WILL GIVE SIGNAL TO THE DCS WHAT HAPPEN TO THE 24 VOLTS POWER SUPPLY IT WILL DROP OR REMAIN TO 24 VOLTS POWER SUPPLY.

3 Answers