Answer / abhi

gauge saver /snubber for various applimn

its range is fixed

how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.

0 Answers   KNPC,

---

why are set -10vdc in bently neveda vibration system.

4 Answers  

---

How can i solve the problem of ROSEMOUNT 5300 guided wave level transmitter of full range? For more clearfication , another guided wave level transmitter VEGA brand have the same problem and i solved it by drain the champer from water and make "false signal suppretion" from transmitter push buttons it's configuration to tell the transmitter to avoid any built-up signal ,,, so my question how can i avoid the problem that rosemount read full range while the champer empty or any other ????

1 Answers  

---

what is meant by nuclear collector?

0 Answers  

---

can i get any detail of interview question asked for instrumentation,plc,scada ,dcs..............

2 Answers   Asec, Honeywell,

---

What standards are used for earthing of field instruments?

1 Answers  

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

How do you troubleshoot accelerometers used in Vibration monitoring/tripping

1 Answers   Air Liquide,

---

Hi, Is there any smart plant instrumentation design training institute in Bangalore?

0 Answers  

---

If mVolts can drop by resistance of wire as compare to mA, then how thermocouple mV reaches in CCR as accurate value?

7 Answers  

---

which type signal in & out in dcs

4 Answers  

---

what is the calibration procedure for transweigh make weigh feeder?

0 Answers   Anjani Cements,

---