Answer / sunil

First of all we maintain a communication protocol between Plc and drive then only operate i.e modbus communication

Answer / dipesh shrivastava

All plc's work under four checks
Ai - Analog I/p
Ao- Analog o/p
Di - dig I/p
Do- Dig o/p
Commands like Motor on & Off are Do's
Commands like Drive operation, control valves operations means any type of partial operations between its low range and high range will be AO
Inputs are of 3 major types , (0-5) V DC, (0-10)v DC & (4-20) mA
All types of feedbacks like proximity ( PNP,Npn ) then feebbacks like actuator open/close, Motor on/off/trip, Feeder healthy/not healthy will be Digital inputs

Is it possible to drill additional gland hole in EExd or EExe JBs? What are the points to take care?

2 Answers  

---

In which principles tx ,pressure gauge,Temp gauge,control valve works?

0 Answers   Bajaj, Professional Instruments,

---

How to Calibrate Temperature Switch in field

0 Answers  

---

how control valve works?

7 Answers   Qatar Airlines,

---

i have one temperature TX in my loop check time once i was remove elament temp gose maximum then i am conect corectly but still now temp showing maximum what can i do this problem?

2 Answers  

---

what is the difference between profibus and controlnet networking.

0 Answers   HZL,

---

Someone please do mail me some instrumentation questions for Hindustan Petroleum test to avinalexander@gmail.com .Really would be gateful if someone could help me

3 Answers   HPCL, Immersion, IOCL,

---

why 4-20 mA in covection system?

3 Answers  

---

What is heating effect?

0 Answers   Process Control Technologies,

---

how to online calibration of remote seal tx.

0 Answers  

---

how to draw a flowchart for swapping two numbers using bit wise operators?

1 Answers  

---

Dear friends, I have a question: We work on a project which has some boilers to provide steam for desalination unit. The boiler area is safe and the only hazard source is the fuel lines of boilers. I want to know according to NFPA standard which type of instrument should be selected on the fuel line: Eex Type or Non-Eex type? Thanks in advance

2 Answers  

---