Answer / yashwant

FIRST INTERLOCK SHOULD BE FURNACE PRESSURE(IT WILL BE 0-50
MMWC)WHICH WILL BE APPLIED TO ID, FD, SA,GA ANY TRIPPING CKT.
SECONDLY VERY HIGH TEMPERATURE/PRESSURE. OTHERS ARE FEED WATER
LEVEL, FUEL QTY ETC

Can I put my meter across an RTD to check it safely witout tripping the equipment when it is connected to an monitoring device eg.RTD module or IQ 1000

1 Answers  

---

what are the selections available in configuring a burnout protection of a controller? thanks

0 Answers   NPC Alliance Corporation,

---

what is preventive maintenance , explain with difination

1 Answers   Bapco Bahrain Petroleum Company,

---

why we are using ungrounded RTD sensor and what is difference between grounded RTD and Ungrounded?

1 Answers  

---

What is the difference between DCS and SCADA?

1 Answers  

---

Explain ratio control system.

1 Answers  

---

what is procedure of calibration of remote seal transmiter, botom to top flanch 850mm, fluid liquid density .73, transmiter fixed on a fractionation colum, under vaccume 10mbar

4 Answers  

---

waht is difference between pressure transmitter and transuducer

4 Answers   Gasco,

---

What is the formula to know the error of weighfeeder after having drop test.

3 Answers  

---

How does your previous experience relate to the job you are applying for ?

0 Answers  

---

why the discharge pressure of ID fan showing negative at fan running condition.(boiler operating condition.)

5 Answers  

---

If an Instrument has 550 ohm internal resistance and the cable used for that instrument is 0.5 ohm per meter resistance. If the voltage is 12volt.How much length cable can be used? Please tell me its Calculation formula.

5 Answers   MOL,

---