Answer / rakesh kumar .n be

Drum level can be measured by , first find the pressure difference between H.P and L.P,so that we can find the differential pressure. then by using the formula p=density*gravity*height , we knew the pressure now, then density and gravity also we knew, then find height.

Answer / mohamed yousuf(instrumentation

first of all we have to measure the height of the drum.
for example if u take the height of the drum is 1meter
(1000mm).
next we have to mesure the head pressure by using this
formula
P=density*gravity*height
gravity is constant so neglect it
density of water is 1 so
P=1*1000=1000mm of water column
so we have to calirate the transmitter with -1000 to 0 mm
of water column.

low range value=-1000
high range value=0
since the water pressure is always appliied on the low
pressure side the transmitter shows -1000mm for zero level
and 0 for high level ie 1 meter

how many type of plug are used in pneumatic control valve,name them.

2 Answers   Godrej,

---

how to test rotor &stator earth fault in turbine

1 Answers   Bhel,

---

which transister (npn or pnp) is used in vibration monitoring for negative voltage? 

2 Answers  

---

What is the working principal of Mass flow transmitter?

1 Answers  

---

how the transmitter send MA?

1 Answers  

---

what is datum line?

4 Answers  

---

A temperature sensor (RTD) connected via a temperature transmitter is adjusted to give an output of 4ma at 60 deg and 20 ma at 600 deg. This output (4-20ma) from the transmitter is connected to an IGBT-inverter to control a high speed (-12,000 to +12,000 RPM) DC motor. And in the inverter it is programmed as, for 4ma the motor speed will be -3,000 RPM and for 20ma the motor speed will be +10,000 RPM. The question is : If the motor speed is +5,500 (RPM), what will be the temperature? (-sign indicates that the motion is in reverse direction).

9 Answers  

---

Determine the manipulated variable, controlled variable, and the measured variable given a description of various typical industrial processes.

6 Answers   Honeywell,

---

What is the use instrument barriers? Can you give me review materials about this?

1 Answers  

---

how can you change unit of totalizer in siemens mag 5000 flow meter?

2 Answers   PowerTech,

---

Which is your favourite subject & explain any one topic of it.

0 Answers   L&T,

---

In RTU Panel we are having several Analogue & Digital Inputs /Outputs. We are recently facing some problems over Analog inputs , which are not updating properly (But Digital Input are updating normally) Can any one tell me from where the problem is creating , we have checked PLC CPU card, Analog Input card & we reconfigured ,But still the issue is there. Issue : 1. Sometimes Analog values are updating & sometimes not. 2. Analog values are not updating normally , showing some wrong Values 3. Total dead (0 value) Analog values are Level & flow measurement from the field instruments. (But in field the instruments are working normally & Displaying the values normally in local display unit) This problem we are facing in our Water Plant. If any one experienced this same problem or having any ideas related to our issue PLS send your valuable Answers/Replies...

6 Answers   L&T,

---