what is megar testing

Question Posted / prasanth

4 Answers
16167 Views
NASA, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is megar testing..

Answer / muili ibrahim

Megger tester is a device normally used to measure insulation resistance conductors such electric motor coils, cables, busbar, etc.

Is This Answer Correct ?

29 Yes

2 No

what is megar testing..

Answer / n.k baghel

Meger is adevice by which we calculate the high valuw of insulation. and we are use for motor.cable etc.

Is This Answer Correct ?

8 Yes

2 No

what is megar testing..

Answer / suraj kumar

Meger is the Device for Resistance measurement of Motors, LT Cables , HT Cables and Bus bars etc. We Can Confirm faults in Line According to the resistance value with the help of a meger .

Is This Answer Correct ?

8 Yes

3 No

what is megar testing..

Answer / monu singh

Meger is a device it is measure the insulation capacity of cble

Is This Answer Correct ?

10 Yes

6 No

Post New Answer

More Electrical Engineering Interview Questions

How to take the Vector Group Test in Transformer? What is the purpose of doing Vector Group Test?

3 Answers

Is a d.c.compound motor is use as a booster? how?

0 Answers

what is the radio of kva & kvar or why calculated kva & kvar

3 Answers

What is bridge rectifier and explain with details

0 Answers

what is p.s impedance measurement test in earthing transformer?

0 Answers Greenko,

We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?

0 Answers Siemens,

What do you mean by nominal ratio of instrument transformer?

1 Answers

why the star delta motors burn out frequently

1 Answers

WHAT IS THE difference betwwen LT CABLE AND CONTROL CABLE

5 Answers

why near the transformers, the Jelly(small white colored rocks)are poured.and what are conditions for that?

3 Answers

how we can use resistance heating for any domestic purpose???

2 Answers

what happens if you swap F1 and F2 connection in the exiter of the generator?

1 Answers

For more Electrical Engineering Interview Questions Click Here