Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / muili ibrahim
Megger tester is a device normally used to measure insulation resistance conductors such electric motor coils, cables, busbar, etc.
| Is This Answer Correct ? | 29 Yes | 2 No |
Post New Answer View All Answers
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
How to check the LM324 Ic
wish of these transformer uses oil?
What are motor generator sets and explain the different ways the motor generator set can be used ?
what are symmetrical and non symmetrical components in electrical installation.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what causes contact chatter when there is no demand on the air conditioning unit?
How much earthing frequency is capable?
what percent do you derate your copper wire when you change from copper buss to copper wire
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
completed BE & done apprentice at tneb & having experience 6 years. want to get c license. will apprentiship & BE be helpful for getting c license. will i get any preference by showing this?
what are the sample questions asking to the test cunducting for electrical superwising lisence test?
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
State thevenintheorem?
