Answer Posted / suraj kumar
Meger is the Device for Resistance measurement of Motors, LT Cables , HT Cables and Bus bars etc. We Can Confirm faults in Line According to the resistance value with the help of a meger .
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
what is the function of choke in the flourcent tube lights and why the colour is in white mostly in flourcent tube lights
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
What is MS-EXCELL?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
what is a reactive power? what is the relation with power factor?
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
Operation of isolators.
Why neutral point is consider as zero potential?
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What is the classification of hydro projects based on installed capacity?
What is the difference between indoor and outdoor transformer
What is the use of oil in transformers?
