Answer / k r kumar ranjan

Normally In Coal based thermal power plant(Either Sub or Super Critical) 60% Bypass is adopted based on condenser heat load calculation keeping 0.9 as Condenser Cleanliness Factor.
If Some designer wants to bypass 100% of generated steam, it is also possible. In fact most Nuclear Steam Turbine adopt same for same reactor shutdown process.
Increase in % capacity of bypass system increases capital cost involved in condenser cooling surface, Extraction pumps, LP Heaters, Pipe Sizing etc.

what is the condition of transformer parallel operation ?

3 Answers   BEDL,

---

What vibration parameters are monitored in a directly coupled single cylinder turbine and generator?

1 Answers  

---

What is wheel chamber in steam turbine?is it impulse blades are called wheel chamber in the steam turbine?

1 Answers  

---

Due to the sensitive earth fault Our Power plant Get Tripped Several Times, It happens in the morning time daily, When temperature rises that means sun rises the earth fault current get lower, in this situation What should I do to get rid of this Problem?

2 Answers  

---

why prds line tapping taken from ms line as Pri SH O/L temp & pressure is sufficient to full fill our requirement of PRDS..

3 Answers   GIPCL, OEGI,

---

What is the the sequence/logic of burner management system in boilers. What is purging and scavenging?

2 Answers  

---

In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,

---

What is LB-SR.

0 Answers  

---

Difference between electrical and electronics?

7 Answers   Power Plant,

---

what is CT saturate?and which effect on CT after its saturate?

4 Answers  

---

What is reheater protection based on what mft will be act on RH protection

2 Answers  

---

What happens if there is no HP and LP By-pass.

5 Answers  

---