Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k r kumar ranjan
Normally In Coal based thermal power plant(Either Sub or Super Critical) 60% Bypass is adopted based on condenser heat load calculation keeping 0.9 as Condenser Cleanliness Factor.
If Some designer wants to bypass 100% of generated steam, it is also possible. In fact most Nuclear Steam Turbine adopt same for same reactor shutdown process.
Increase in % capacity of bypass system increases capital cost involved in condenser cooling surface, Extraction pumps, LP Heaters, Pipe Sizing etc.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
procedure of how to generate power in solar plant.
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
explain how the third harmonic content of the magnetising current affects transformer design
We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
what is the difference between compensated & normal drum level in boiler drum?
what is natural frequency of turbine shaft .
what is the meaning of SST300 V56A in SIEMENS turbine
How to calculate power press toneage
what is the basic use of power plant in equipment
what's the moog valve
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
what is the trip circuit supervision in an electrical meaning?
