Answer / powerplant.calculations

Turbine vibrations are measured on Turbine front , rear & thrust bearings
Gear box bearings
ALternator bearings

Also refer
https://www.powerplantandcalculations.com/2020/06/why-do-vibrations-occur-in-machines.html

In a thermal power plant ID Fans running with full load but boiler load is only 80 % give reason ?

9 Answers   Essar, Prumatech, Tata Power,

---

What happens if lizard comes in a MOCB

1 Answers   ABB, Reliance,

---

63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????

2 Answers   UET,

---

What is the use of Hydraulic Coupling in-between BFP pump & BFP Motor?

1 Answers   Lanco, XYZ,

---

1. what is meant by burner tilting?

3 Answers  

---

What is precaution and after implication for 100% pet coke firing in AFBC Boilers?

1 Answers   Grasim,

---

Planning Engineer interview model question and answer

1 Answers   Tata Power,

---

I want to build 100 megawatt hydel dam. What does mean, 100 MW per hour? then how many electric bulb of 100 Watts the dam would lit?

1 Answers  

---

what is scanner air fan & how dose it work & is there any interlock in power plant

3 Answers   APGenco,

---

why airtel use + 24 volts and other operators use -48 volt

0 Answers   ABC, Airtel, INDUS, Reliance,

---

What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?

0 Answers   RasGas,

---

What is reheated protection

1 Answers  

---