How turns ratio test is done in three phase transformers?
Answers were Sorted based on User's Feedback
Answer / varun kumar
The ratio test for measure the ratio between primary to secondary with each. From this test we can determine the each tap alignment and Their ratio error
Is This Answer Correct ? | 1 Yes | 0 No |
Why there is a current in neutral line
What is the full form of CNC in electrical mechines.......?
If the capacity of water Tank is 50000 Liters situated at 20 meters height from ground level,What would be the size of pipe and how much USGPH water will be supplied and what will be the motor or pump rating used for this work?Illustrate by showing formula?
how is the magnetic current test is different in delta-star and delta delta transformer.
in most industies hormonics present up to some level. what is limit ? and there effect?
A 100 MVA transformer may be cooled with?
Recently we had experienced following problem All RCCB breakers (connected to the load as well as spares) connected to various UPS systems at various floors at a high rise building tripped during a power break down and upon starting up of generator.This Generator is recently inducted into the installation. Can any one explain the reason behind this tripping. Regards Viswanathan
What is meant by class of CT&PT?
why induction motor takes high current?
in soft starter system for 375 KW 3 ph induction motor for multi stage vertical pump, two thyristers failed causing shorting of thyrister. the motor winding failed while starting.What is the cause and what is the effect in above case
In order that work may be done:(a) Two wires are necessary(b) The circuit must have a switch(c) Coal must be burnt(d) A supply of energy is required
At light load transformer efficiency is less because A secondary output is low B transformer losses are high C fixed loss is high compared to output D copper loss is small