what kind of motor is used for lifting applications
Answers were Sorted based on User's Feedback
Answer / manoj
the motor should have high starting torque to lift
which is offered by
DC SERIES MOTOR
THREE PHASE SLIP RING INDUCTION MOTOR
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / ravi chandra
In the case of lift and flights they need high starting
torque...
so 3 phase slip ring induction motor will be used.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / amir siddiqui
DC series motor should be used because for lifting purpose there is a requirement of high torque
Torque=1speed(N)
| Is This Answer Correct ? | 0 Yes | 0 No |
In case of 3Phase Supply, Voltage R-Earth/Neutral - 220 Y-Earth/Neutral - 220 Z-Earth/Neutral - 220 Total is -> 660Volts Then Why it is said that 3Phase supply is 440
6 Answers Hindustan Unilever Limited,
How to address the servo drive for motor
what is the design factor that affects the size of a motor ?
why control circuit voltage always chooses to be 110v and 220v? and in where it is 110v and 220v? and in where it AC and DC?
Can we parallel two grid with different incoming voltage. Ex.let say one grid is 132kv and another is 220kv.
Why machines are avoided to work is saturation region of B- H curve?
What is the difference between Type test and Routine test?
What makes the difference between 50Hz supply and 60Hz supply which one is economical and how can you support your answer...........?
2 Answers Fertichem, Kuwait Oil Company,
why generally transformer are in star to delta or delta to star used?
Testing procedure of DG alternator stability test
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
why use in & out Diesel line in dg set.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)