Answer / robin sharma

Give me the answer's?

Answer / s.rajeshwar

one ton refers to 1000 kg of water.

if we are taking water(any quantity more than estimated) at
0 degree celcius and switch on the machine. If it produces 1
tone of ice in 24 hrs, the capacity is 1 tone. if it produces
100g then its capacity is 0.1 tone like that....

What is an isolation transformer?Why do we need isolate circuits?Where do we use them?

2 Answers  

---

I have 10 amp MCB for my air conditioner of 1.5 ton capacity. When I connect the ac direct it is started running but when connected through stabliser the Mcb Get trip and air conditioner couldn't start.please confirm whether Mcb is required to be upgraded to 20 amp. There is no fault in ac and the stabliser. Please advice the reason of tripping the mcb when connected through the stabliser.

1 Answers  

---

What is the transformenr turns ratio.

5 Answers  

---

which cable is preferred PVC OR XLPE for voltage from 220V to 11 KV with proper justification

1 Answers   BARC, Sail,

---

What is the GI Earth Flat Size recomended for 33KV 2000KVA Distribution Transformer

1 Answers  

---

WHAT IS RMU & HOW IT WORK,IT USEFUL FOR HT OT LT POWER DISTRIBUTION MAUFACTUERE IN INDIA.

2 Answers  

---

For a Potential Transformer(PT), the primary neutral terminal must be grounded before energization. Why....? What will be heppend if we energize the PT without grounded the primary neutral point? Why..........?

2 Answers  

---

What is the difference between 11kv/110v & 33kv/110v ? If both 11 & 33KV give 110v then what is the diiference ?

1 Answers  

---

Rated moter voltage and frequency is 380volt 60 hz but moter is running at 380votac 50hz is this harmful for moter winding

1 Answers   Infosys,

---

if the synchronizing b/w generator and busbar not complete and we close the out going circuit breaker of generator then what happen ?

4 Answers  

---

Can someone help me in the Below Quest on Earthing 1.Types of Earthing and Recommended for what use 2.What is the Pit value /Panel N -E value should be or within limit for RP and UPS .

1 Answers  

---

Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection

0 Answers  

---