Transmission line design. Say, I have a 1MVA generator and 2 transformers tha

Transmission line design. Say, I have a 1MVA generator and
2 transformers that will have the same load. What would be
the proper rating of the trasformers? Is it safe to say,
that I will simply divide the total rating of the generator?

Question Posted / ianeil18

1 Answers
3821 Views
I also Faced
E-Mail Answers

Transmission line design. Say, I have a 1MVA generator and 2 transformers that will have the same..

Answer / k.prakashchandra

Each generator should have its own tr called UGT (unit gen
tr) for unit differential protection .The capacity of tr is
equal to or a little more than that of gen .

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

When measuring the Insulation resistance of a motor winding (winding to earth) using a megger meter, Applied voltage(1000V) was automatically reduced to 500V. and the measured insulation resistance values are also very low (in Kohm range) Can anyone give me a reason???

3 Answers

What is annunciator ?

1 Answers

why does voltage generation at 11 kv?

2 Answers

what effect will 10 milliampere current cause to human body ???

1 Answers

Hello sir This is prakash from bangalore i have a doubt why we have to maintain DG power factor in the range 0.78 to 0.8 Perhaps i f it is increased means what will happen in DG

3 Answers

what is an impedance & inductance ?

4 Answers

what is mean by current

17 Answers Wipro,

What are the function of different components of servo motor?

0 Answers BARC, Parle,

what are effects of harmonics in the three phase a.c power system ?

2 Answers AIIMS,

what is current actully?significance of current...not rate of change of flow.....

3 Answers

WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE

0 Answers Siemens,

What is the use of doing meggering for a cable

2 Answers

For more Electrical Engineering Interview Questions Click Here