What is the meager?
Answers were Sorted based on User's Feedback
Answer / attique330
meager is instrument which is used to measurement of high
resistance of insulation and quality.
Is This Answer Correct ? | 38 Yes | 5 No |
Answer / rajesh upadhyay
megger used for any winding insulation resistance
mesurement.
Is This Answer Correct ? | 10 Yes | 2 No |
Answer / pradyumna chandra panda
Meager(Insulation Tester) is used for measer high value of resistance such mega ohm, gega ohm, tera ohm which offer in between cable core , winding and body etc. NB. Some time we wrongly say that value a apparatus or a cable is infinative maga ohm. Actualy there is a vaule of Mega , gega or ,tera which is determine by using high range of meager of high voltage.
Is This Answer Correct ? | 8 Yes | 1 No |
Most likely the misspelled "Megger". Megger is a company whose Insulation Resistance meter is so well known; people usually associates any insulation resistance meter as 'megger tester'.
Is This Answer Correct ? | 10 Yes | 8 No |
Answer / guest
megar is nothing but to check the IR value of the cable .and
also use for cable fault find
Is This Answer Correct ? | 3 Yes | 2 No |
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
USE OF 8 WAY PAN ASSEMBLY
cable tray sizing & selection
prove that power consumed in 3 phase delta system is 3 times as compared to 3 phase star system
why a three phase induction motor cannot run at synchronous speed ?
Why diversity factor are applied to the load?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
my project load is 6 MW so please suggest the size of cable.. ALU 3c 400 aqmm cable can be sufficient.. is there any thumb rule for calculation of cable size please help me
What is the differance between negative dc voltage and positive dc voltage because some circuit uses -24,-5,-12,- 15,volt dc supply
10 Answers eLab, Hero Honda, NTPC, Suzlon, Teradyne,
can we synchronize star system generators with delta system generators?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
should Dy11 and Dy1 group can be operated in parallel??????