Answer / meenakshi

in order to have stationary poles (fixed N and S),we use dc
source.

in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?

0 Answers  

---

what is meant by MCB and MCCB? and what its full form?

7 Answers   Bajaj, JHM Hotels,

---

to operate air conditioner of 1.5ton what power of generator is required

1 Answers   Bharat,

---

Which cable is use for rtcc control panel

0 Answers  

---

why after termination of HT cable armoured earth connected one end, why not connect other end.pls tell me correct answer.

3 Answers  

---

---

where the lexical paramater will use in fron end?

0 Answers  

---

Is it recommended to apply H.pot test for new cables segments after terminations or joints, however, this cable has been tested before at the manufactor by the vendor ? or only we can apply megger tests ?

1 Answers   Centroid,

---

Dear all, how we select the cable size according  to current with or without including different correction factor , is there any direct method for sizing of cable... 

0 Answers   Kharafi National,

---

what is the difference between series and shunt compensation using facts in a transmission line

8 Answers   College School Exams Tests, Genco,

---

single sphase energy meter measur

7 Answers  

---

what is the difference b/w conductor and semicoductor

1 Answers  

---

what is the maximum rating(KVA) of transformer can be used in distribution side..(11KV/440v) and why??

1 Answers   Jindal,

---