Answer / arti

11kV is the transmitted voltage. Voltage is usually
transmitted at higher voltage so as to save the cost of
copper (conductor side).
All the domestic appliances as per Indian standards are
rated at 250V and P-N voltage tapped from a phase of 3-
phase 440V is 250V (440/ sqrt(3)) approx. So 11kV/440V is
used for distribution suply.

Answer / sathish

This stage is called as secondary distrbution in this stage they convert ffom 3 wire to 4 wire system. In domestic we need l-n or r-y-b-n

Answer / yasuteru

because domestic appliances work on low voltages

what is differnce btwen lll and lllg faults

0 Answers  

---

what is pole slip ?

4 Answers   NTPC,

---

what is the Maximum voltage range for single phase

4 Answers  

---

How to find ampere on ht side for selection of cable size ???

0 Answers  

---

In Panels Main Incomer considered should be TPN or FP?

2 Answers  

---

---

How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?

0 Answers   ABB,

---

can u describe the method used for protection of transmission line.

0 Answers   IBM,

---

Why motor initial starting current is high?

9 Answers   Pennar,

---

dg earth connect only in the amf panel or not why

0 Answers  

---

what is mathematical relation between ac to dc current how will convert Iac=50amp to Idc

7 Answers  

---

In which connection the distribution T/F is connected? a) ▲ / Y b) Y / ▲ c) ▲ / ▲ d) Y / Y

4 Answers  

---

is it possible to say motor horsepower number without seeing name plate(when name plate damaged)

3 Answers  

---