Answer / pankaj

you can contact me on pankajpsonawane14@gmail.com

Mumbai.(Monarch Solutions)

Level in tank under vacuum (Ex: Condensate Tank of Power Plant)is measured using D. P. type level transmitter. Tank is subjected to vacuum of 755mmHg. Is it possible to fill wet leg ( i.e. leg connected to top of vessel with low point of D. P. xmtr) with water?. Are there chances of water getting sucked under vacuum? if yes, what is the solution?

3 Answers  

---

how to control motor load with rpm or vfd

1 Answers  

---

If we increase D what will be the controller action?

2 Answers  

---

how to explain PID?

2 Answers   Jindal,

---

Induction type 1-p wattmeter reads ….. a) true value b) apparent value c)volt ampere value

3 Answers   Engineers India Limited,

---

where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com

0 Answers  

---

why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V

0 Answers   Hospira,

---

During valve sizing from all calculation you got flow coefficient CV 12,than what it means? like for selecting pressure transmitter if your MAWP is 12 bar than you select a capsule of max. 20 bar which cover your mawp 12 in same way for selecting control valve If CV is 12 than how we use it in selecting valve??????

1 Answers  

---

What is ptw and write 3 types of ptw?

5 Answers   Emco,

---

why we are using negative range like -750 to 0 mmwc in closed tank?and what is the reason can you explain clear?

2 Answers   Aarvi Encon,

---

What is T4 temperature in compressor?

1 Answers  

---

Explain Difference between Bech set and operating range of control valve

3 Answers  

---