Interested to Buy Any Domain ? << Click Here >> for more details...
please anyone suggest me some good intools training
institutes with their place and contact nos.
- 1 Answers
- 4180 Views
- ABB, Thermax, I also Faced
- E-Mail Answers
Answer Posted / pankaj
you can contact me on pankajpsonawane14@gmail.com
Mumbai.(Monarch Solutions)
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why flow/pressure transmitter before control valve?
What is Span Error
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
Draw block digram for well head from well to shipping pump?
how to calculate range of level transmitter?
i am having information technology branh ....... can i prepare for psu exam
Decibel.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
How to convert milliampares into flow??
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
How flow can be measured with dp?
How the sizing of the analog signal cable is calculate?
