1.can you use SCADA instead of DCS,DCS instead SCADA
2.Difference between DCS and PLC,can their role be reversed i.e. role interchange
3.Difference between RTU and PLC
No Answer is Posted For this Question
Be the First to Post Answer
What are all the type of vibration measurement measuring in turbine, what is the output of vibration sensor.
What is the minimum rating availalbe for weld neck orifice in market?
why 4-20 mA signal is preferred over a 0-10V signal
what is an ambient temperature?
what is burner management system?
in a electronic controller why we are using 250 ohm resistance in input signal?is i/p is necessary in control valve when we are using electronic controller give details?
what is isolation Transformer???...
Explain why plc require in analog input 4-20amp & 0-10 volt?
why is negative range given to measure the steam drum level
Explain Three way boiler.
Yokogawa dcs normally where will change 4-20 MA to DC voltage( node or I/o cards?)
Explain PID controller tuning & any one method used for it.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)