In bimetallic temp. Gauges why does metal strip bend? Why do we use low expansio

In bimetallic temp. Gauges why does metal strip bend? Why do we use low expansion factor metal and high expansion factor metal in bimetaliv strip?

Question Posted / aniketskadam007

1 Answers
3010 Views
Process Control Technologies, I also Faced
E-Mail Answers

In bimetallic temp. Gauges why does metal strip bend? Why do we use low expansion factor metal and h..

Answer / umar

Because of amplification of bending

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?

0 Answers

what is see back effect?

9 Answers

What is the use of the shield wire and how is the connection at both the ends of a shield wire?

2 Answers Samsung,

-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.

0 Answers

What is cascade control in process instrumentation?

4 Answers Engineers India, ITC Infotech,

is motorized valve closed when power shutoff?

0 Answers Unilever,

in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.

0 Answers

What is seeback effect?

3 Answers

if found error in magnetic flow meter?how can we adjust?

2 Answers ANI Instruments, Techint,

how to test rotor &stator earth fault in turbine

1 Answers Bhel,

what is insdustrial vibration.who it works. give atleast 2 types of insdustrial vibration

0 Answers

what is zero and span ?

0 Answers

For more Instrumentation Interview Questions Click Here