if an alternator or turbine using fuel to produce ele energy and we didn't connect load to the ends then where was gone the ele energy
Answers were Sorted based on User's Feedback
Answer / ashok bhatnagar
The energy goes in friction and windage losses in running
the turbine and generator. If you load the generator more
fuel will be required to maintain the speed. If you do not
connect the load then any increase in fuel supply will
increase the turbine-generator speed.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / ghanshyam_singh
quite satisfied with the previous ans. simply the speed of the rotor will increase because there is no opposing force which acts on rotor.
| Is This Answer Correct ? | 0 Yes | 0 No |
what is the basic principle of the alternator ????
what bridge circuit is used in Tandelta circuit
How to calculat the ratio of HT\LT in energy meter
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
How many gap between finger contact in a.c.b. and v.cb.?
What is the difference between Neutral and Eatrh?
how mass curve differs from hydrograph.
what is the voltage between nutral and earth?
What is mean by powerfactor. What is the difference between leading and lagging power factor?
what is leading and laging please in details
Why 66KV is step down to 11KV and then 433v, not directly 66KV to 433v ?
Can anyone explain, How will get positive to ground and negative to ground reference voltage in dc system
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)