Answer / susant kumar acharjya

you can measure the earth pit through meggar.
take two rod of 45 cm . one rod erect 30 mtr from earth pit and connect a cable with that rod and the second end connect at earth of meggar,2nd rod 90 degree to first rod at the distance of 40 mtr from the earth pit again connect with cable and the 2nd of with meggar guard. two probe of meggar connect to the earth pipe . rotate the meggar u wil get les than 1 ohm

Answer / p.seenichamy

The minimum valus of single earth pit is less than 1 ohm

Answer / mahaveer sahu

Earth pit value can be measured by digital earth tester and the minimum value of single earth pit should be less than 2 ohm

What's is the difference between IVT and CVT?

1 Answers   CPCL,

---

What is PLL? what are it's advantages?

1 Answers   BREB,

---

How to calculate phase to phase difference ?

0 Answers  

---

Why control of DC motor is simpler?

0 Answers   BARC,

---

a battery is having capacity 100AH and 25% charging .if a load taking 10A & connected 6 hour .what is the final condition of the battery.

0 Answers  

---

In which iron losses is higher induction motor /transformer

1 Answers  

---

What are the components of feedback control system?

0 Answers  

---

what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.

0 Answers  

---

Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.

0 Answers  

---

can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?

0 Answers  

---

why high speed tripping relay is used in protection circuit why not normal relay

0 Answers  

---

What is the diffrence between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?

1 Answers  

---